- dmitriy-kirilovgrism
- Member
Offline - From: Россия
- Registered: 4/12/2025
- Posts: 24
Re: Branding and design
Welcome
I moved your post here, as we dont want discussions in the library section. Hope you get help with these interesting thoughts.
Torsten
- CliftonLak
- Member
Offline
- From: Hungary
- Registered: 5/23/2025
- Posts: 14
Re: Branding and design
Thank you for moving this to the correct place Totte. And the welcome. Very interesting work you are all doing here.
Thank you magnus, yes I understand your commemts. Yes they do cut wide but I would reshape the teeth so that is not a big problem. The large pitch is more of a problem Yes they woul not travel efficiently around small diameter bars. I am doing research so any information is possitive. I may have to design and make a punch and die to manufactor my own links, with the profile I want. I was hoping to find something already made that I can adapt as it is much cheaper. I have looked at Prinze now and found good information.. Who are the others you know who make special chains? Does anyone on the forum make their own links, and if so would they help Me? Thank you for your time.
Roger.
- CliftonLak
- Member
Offline
- From: Hungary
- Registered: 5/23/2025
- Posts: 14
Re: Branding and design
To get these scratcher chains to run on a small tip bar and in smaller pitches I would say is pretty unlikely.
The cut these do is pretty wide and not as smooth as the semichisel or chisel tooth.
There is new chains to be found as they are made in small scale still and sold by Prinze and others.